This is Gentoo's testing wiki. It is a non-operational environment and its textual content is outdated.
Please visit our production wiki at https://wiki.gentoo.org
Handbook:HPPA/Installation/Bootloader
Installing PALO
On the PA-RISC platform, the boot loader is called palo. First merge this bootloader to the system:
root #emerge --ask sys-boot/paloThe configuration file will be found at /etc/palo.conf. Below is a sample configuration:
/etc/palo.confSimple PALO configuration example--commandline=2/kernel-3.16.5-gentoo root=/dev/sda4 --recoverykernel=/vmlinux.old --init-partitioned=/dev/sda
The first line tells palo the location of the kernel and which boot parameters it must use. The string 2/kernel-3.16.5-gentoo means the kernel named /kernel-3.16.5-gentoo resides on the second partition. Beware, the path to the kernel is relative to the boot partition, not to the root partition.
The second line indicates which recovery kernel to use. If it is the first install and there is no recovery kernel (yet), please comment this out. The third line indicates on which disk palo will reside.
When configuration is done, simply run the palo command:
root #palo
Rebooting the system
Exit the chrooted environment and unmount all mounted partitions. Then type in that one magical command that initiates the final, true test: reboot.
root #exitcdimage ~#cd
cdimage ~#umount -l /mnt/gentoo/dev{/shm,/pts,}
cdimage ~#umount -R /mnt/gentoo
cdimage ~#rebootDo not forget to remove the bootable CD, otherwise the CD might be booted again instead of the new Gentoo system.
Once rebooted in the freshly installed Gentoo environment, finish up with Finalizing the Gentoo installation.